S-PIXIE QRP FULLY ASSEMBLED WITH 6 CRYSTALS
Descriptions
This Pixie is assembled and ready to transmit.
It will be sent with 6 crystals listed here 7.030/35/50/55/60/122, with an included Crystal seat you can quickly change frequency, to change frequencies simply pull out 1 frequency and install a different frequency.
Improvements are as follows:
The vertical resistance is changed to horizontal resistance, Solving the problem of resistance to short circuits.
We do not distinguish between positive and negative electrodes of the power supply. The power input range is 9VDC-13.8VDC. But the higher voltage is advisable due to the onboard LM386 chip needs extra power to amp up audio output.
The onboard buzzer sounds for the sidetone of the outgoing code. (use jumper silence), Added led signals when sending code.
Acrylic shell.
Specifications:
Power supply: 9~13.8V Volts DC, >500mA (Recommend the use of batteries) .
Antenna: 50ohm,7MHz, SWR<2.0 Receive: static current 20mA Transmission power: 1.2W Frequency: launch the vibration frequency,7023 KHZ Receives the local oscillator frequency: about 7023-7023 KHZ.
Work mode: CW KEY.